Nor-Lake Kold Locker™ Step-In Freezer - Walk In World

	Panels . . . All panels are manufactured with male and female mating rails to ensure proper alignment during installation. The polyurethane insulation wraps around the return bend metal seams on both section to create a lightweight panel of exceptional strength and durability. All panels are are a full hour (4) inches thick and provide a superior insulating value. The foamed-in-place cam locking fasteners ensure an airtight seal for maximum energy efficiency.
	Insulation . . . The foamed-in-place cam locking fasteners ensure an airtight seal for maximum efficiency.
	Panel Gaskets . . . Kold Locker™ panel gaskets around the outer perimeter of the panel are continuous, without cuts or breaks at corners. The Nor-Lake patented gasket design provides a foamed-in-place gasket as an integral part of the panel. Gaskets cannot fall off or pull off during shipment or installation.
	Energy Efficient . . . Panels lock together tightly to assure an energy-efficient walk-in.
	Edge Caps . . . Edge caps for ends of floor and ceiling panels are foamed-in-place rather than overlapped or mechanically fastened. Edge caps cannot come loose, and they stay in place through the life of the walk-in.
	Panel Finishes . . . Interior and exterior complete to be 26 gauge corrosion resistant stucco embossed coated steel.
	Door . . . Door sections manufactured at Nor-lake are factory tested to assure proper fit, performance and alignment. All doors feature a stepped profile design that serves as a barrier to air flow which results in an energy efficient door system. Each Kold-Locker™ walk-in compartment is equipped with a 26" wide door. The Standard Series has a 66" high door. The door is self-closing, flush-mounted, infitting and constructed to incorporate heavy duty, molded ABS breaker which is permanently foamed-in-place. Doors are available with right or left side hinges and include two cam-lift hinges, top hinge field adjustable with locking set screw, spring actuated door closer, NL 9800 deadbolt locking handle with independent key/padlock feature and inside safety release. The doors are pre-hung in a four foot wide frame panel which is equipped with replaceable perimeter heater wire, magnetic stainless steel trim, digital thermometer, vapor-proof light fixture and switch exterior pilot indicator light. The door section is completely pre-wired within concealed conduit inside the door frame panel. 115/60/1 electrical is field wired to a junction box which is surfaced mounted on the interior frame above the vapor proof light fixture. Hinges and door handle are mounted to 1/2" synthetic insulated tapping plates. Each door section is complete with a fiberglass reinforced plastic heated threshold.
	Floor Construction . . . Floor panels (when supplied) are similar in construction to the wall panels except they are made to withstand uniformly distributed floor loads of up to 800 pounds per square foot. The interior floor metal is smooth aluminum.
	Approvals . . . Kold Locker™ walk-in construction is approved by the National Sanitation Foundation and shall have the N.S.F. seal on the door section. Walk-in panels shall have a U.L. flame spread rating of 25. The door section is U.L. and C-U.L. listed for electrical safety. - Registered by UL to ISO 9001 - City of New York (MEA) listed. - City of Houston listed. - LA County listed. - California Stated listed. - Oregon State listed. - USDA accepted - CEC - NSF Certified - CN Ul flame spread